- -10%
- Pack
- Out-of-Stock
- -10%
Dual Guard Sensor
€11.10
€12.33
Our Dual Guard Sensor allows you to pause your printer in the event of :
- Filament is exhausted
- Filament blocked (overlapping) in your spool (For spool on the top of the Z axis only)
Very simple operating principle by mechanical endstop and neodymium magnets.
The "Pin 27 Board" is required for the original Ender3, Ender3_PRO, Cr10, etc... (Board with ATmega 1284p, Creality 1.1.4,1.1.5,etc..), it allows to free the pin 27 to connect the sensor.
For 4.2.2 and 4.2.7 Creality cards, the PIN27BOARD is not necessary, connect the sensor on the dedicated pin.
Available in 4 options:
- Only the parts, you print the STL provided (See tab "attached documents")
- Only the parts + Pin 27 Board, you print the STL provided (See tab "attached documents")
- Assembled sensor + fixing part.
- Assembled sensor + Pin 27 Board + fixing part.
See "Documentation" tab for complete installation.
STL files in tab "Documents attached" (bottom of pages).
Reviews about this product
-
Philippe A.
Published 25/11/2023 à 07:36 (Order date: 05/11/2023)super.
-
CHRISTIAN V.
Published 16/11/2023 à 20:37 (Order date: 04/11/2023)Conforme à mes attentes
-
Jean-Marc M.
Published 20/06/2023 à 08:14 (Order date: 07/06/2023)Produit astucieux. Un petit peu modifié pour mes besoins
-
Christian A.
Published 06/04/2023 à 19:00 (Order date: 25/03/2023)Axe hexagonale de 7mm livré au lieu de 8mm m'a obligé à réimprimer un nouveau boitier
-
LEBAS C.
Published 16/03/2023 à 20:53 (Order date: 28/02/2023)Parfait
You might also like
- Pack
- -10%
16 other products in the category
Our Dual Guard Sensor allows you to pause your printer in the event of :
- Filament is exhausted
- Filament blocked (overlapping) in your spool (For spool on the top of the Z axis only)
Very simple operating principle by mechanical endstop and neodymium magnets.
The "Pin 27 Board" is required for the original Ender3, Ender3_PRO, Cr10, etc... (Board with ATmega 1284p, Creality 1.1.4,1.1.5,etc..), it allows to free the pin 27 to connect the sensor.
For 4.2.2 and 4.2.7 Creality cards, the PIN27BOARD is not necessary, connect the sensor on the dedicated pin.
Available in 4 options:
- Only the parts, you print the STL provided (See tab "attached documents")
- Only the parts + Pin 27 Board, you print the STL provided (See tab "attached documents")
- Assembled sensor + fixing part.
- Assembled sensor + Pin 27 Board + fixing part.
See "Documentation" tab for complete installation.
STL files in tab "Documents attached" (bottom of pages).