Electrique
-
Ventilator 30x30x10 mm
€7.50Cooling ventilator
Dimensions : 30x30x10 mm
Speed : 10000 Rpm.
Tension : 12 Volt
Type of bearing : double bearing
Length thread : 700 mm -
Ventilator 25x25x10 mm
€2.83 -50% €5.65Ventilator 25x25x10 mm
Tension : 12VDC
Length thread : 700mm
-
-
Blower 4020 S
€4.70Blower 4020 S
Dimensions: 40 x 40 x 20 mm
Voltage : 12 or 24 Volt
Speed : 6500 rpm
Flow rate : 5.4 m3/h
Noise level : 28 Db
Weight : 22 Gr
Cable : 30 cm with JST connectorFor the cooling of the parts during the printing process.
-
Endstop
€2.78Limit switch for 3D printers, for X, Y and Z axis and filament sensor
Supplied with a 1 meter cable, 3 pins JST-HX.
Possibility to supply on 2 (GND,Signal) or 3 pins ( 5V,GND,Signal) according to your board.
-
USBASP
€5.75The USBASP is a microcontroller programmer based on Arduino. (Atmega 1284P).
Essential to inject or modify a firmware on CR10 or Ender3.
It allows to :
- Burn a bootloader, in order to communicate via the USB port.
- To download directly a firmware in .hex on your card.
Delivered with 2x5 pins + 2x5 pins /2x3 pins adapter.
-
Blower 5015
€4.50Blower 5015 , 24 Volt
Available in 2 versions :
- Bronze bearing
- Double bearing (Premium quality, quieter)
For the cooling of the parts during the printing process.
-
Pin 27 board
€6.92Adapter card to retrieve Pin 27 from original Creality Ender3/Ender3PRO, CR10, Cr10 Mini, Ender5 ....
Connects to the IDC pin of your card, connect your BL Touch, filament sensor or any other accessory requiring a control PIN
ATTENTION, for cards without bootloader also provide a USBasp when you buy (Ender3/Ender3PRO, CR10, Cr10 Mini, Ender5)
Incompatible on AnetA8 & CR-8
-
Ceramic heating ring
€9.50Ceramic heating ring
Internal diameter: 8.5 mm
External diameter: 10.5 mm
Height: 8.5 mm
Resistance: 3.6 Ohms
Delivered with its 700 mm long cable and Molex connector
Suitable for the manufacture of very small heating elements