Capteurs

Active filters

  • Dual Guard Sensor

    €12.33

    Our Dual Guard Sensor allows you to pause your printer in the event of :

    • Filament is exhausted
    • Filament blocked (overlapping) in your spool (For spool on the top of the Z axis only)

    Very simple operating principle by mechanical endstop and neodymium magnets.

    The "Pin 27 Board" is required for the original Ender3, Ender3_PRO, Cr10, etc... (Board with ATmega 1284p, Creality 1.1.4,1.1.5,etc..), it allows to free the pin 27 to connect the sensor.

    For 4.2.2 and 4.2.7 Creality cards, the PIN27BOARD is not necessary, connect the sensor on the dedicated pin.

    Available in 4 options:

    1. Only the parts, you print the STL provided (See tab "attached documents")
    2. Only the parts + Pin 27 Board, you print the STL provided (See tab "attached documents")
    3. Assembled sensor + fixing part.
    4. Assembled sensor + Pin 27 Board + fixing part.

    See "Documentation" tab for complete installation.

    STL files in tab "Documents attached" (bottom of pages).

  • Auto Leveling sensor "Touch-MI"

    €19.08

    The " Touch-MI " is an autoleveling sensor.

    It allows you to measure the flatness defects of your printing surface in order to correct them and have a perfect first layer.

    Only 3 very simple steps:

    • Installation on the printer.
    • Firmware settings.
    • Setting the Z Offset 

    This sensor can be initialized manually or automatically (with activation module).

  • Endstop

    €2.78

    Limit switch for 3D printers, for X, Y and Z axis and filament sensor

    Supplied with a 1 meter cable, 3 pins JST-HX.

    Possibility to supply on 2 (GND,Signal) or 3 pins ( 5V,GND,Signal) according to your board.

  • DualGuard Artillery

    €14.08

    Our Dual Guard Sensor allows you to pause your printer in the event of :

    Filament is exhausted

    Filament blocked (overlapping) in your spool (For spool on the top of the Z axis only)

    Very simple operating principle by mechanical endstop and neodymium magnets.

    Replaces the original sensor on Sidewinder X1, X2, Genius and Genius PRO.

    Video of operation and installation in the description tab below.