
- -10%
Magnet-FIT, the fast and long-lasting connectivity for your hotend.
Magnet-FIT, is a system of fast magnetized connection between your PTFE tube and your hotend.
Le kit includes:
- a PTFE tube 4/2 mm. (1000 mm)
- a magnet
- a metal washer
- sandpaper
Glue not supplied, we recommend the use of the Great glue LOCTITE Glue Mini Trio 3 X 1g Tube.
Magnet-FIT replaces the pneufit !
No Backlash) in the connection !
It mounts and dismounts very quickly and especially not deteriorate as a pneufit !
It resists a thrust de 6KG, even a cold extrusion does not unstick the magnet!!!
Magnet-FIT, addresses printers with deported extrudeur 1.75 mm ( Bowden) and hotend Metal (Aluminum, Stainless steel).
The magnet is preassembled on the PTFE tube.
By means of the sandpaper, clean the contact areas of the washer and the hotend.
Center your washer on the magnet.
Insert a filament tip 1.75 mm in the PTFE tube.
Apply a little bit of glue Cyano (not supplied) at the top of the hotend.
Place in contact the washer with the hotend and maintain a few seconds until the setting time.
You are ready to print:)
Attention if you have to screw the PTFE tube in the magnet for differents reasons please well control that the filament is not stuck in the tube.
If the filament stucks, use a 2 mm drill in the PTFE tube.
systeme tres ingenieux ,une fois adopté s est pour toujours...
Parfait
Parfait
Non utilisé
super matos